Safety Monitor ASCOM driver allowing knowing the safety condition by using an IPX800 v2, IPX800 v3 or IPX800 v4 input.

It is, for example, possible to use a cloud or rain sensor

IPX800 v3
IPX800 v2
  • Microsoft .NET Framework 4.5 or above
  • Plateform ASCOM 6.2 or above

configuration dialog

IPX800 settings

IPX800 version

Version of the IPX800: version 2, version 3 or version 4

Protocol

The IPX800 can be controlled using two protocols: M2M (Machine to Machine) or HTTP (equivalent to a control by the web interface).

Note: In case of use of an X880 extension and a firmware version older than v3.05.46 it's recommended to use the HTTP protocol; the extensions do not always react properly to the M2M commands with older version.

IP address and port

IP address and port of the IPX800.

The default port numbers are: 9870 for M2M protocol and 80 for the HTTP protocol.

User and password

The user and password configured to access the web interface of IPX800.

When using the M2M protocol, the password is only required if the firmware version is 5.3.46 or higher.

Sensor settings

Input

Input on which is connected the sensor

Is safe when

Define if the conditions are safe when the IPX800 input is active, or when it is inactive.

v1.0.0 (2019-03-17)

  • Initial version

This software is free, but any donation is welcome

Download IPX800-SafetyMonitor_Setup_v1.0.0.exe 1001297 bytes